ERP Power's PDB series programmable LED drivers are targeted for deployment in area, floodlight, parking garage, roadway, tunnel, and other outdoor lighting fixtures. In a typical street lighting application, a single ERP driver can replace market alternatives that require two drivers. The ERP single-driver approach requires up to 60% less space at less than one half the cost. Constant current output is high-efficiency and fully programmable from 150 W to 260 W in a wide range of output currents and voltages while maintaining efficiency of 93% from 50% to 100% of load. ERP drivers are designed in California and built to last with a 5-year limited warranty.
Features |
|
|
- Programmable:
- Current: 100% to 50% in each voltage range
- Output voltage range selection
- Datalog read: SKU, S/N, lot code, hours of operation, FW rev., fault events: power failure, transients (short or surge), thermal events
- Non-linear 0 V to10 V dimming profile with dim-to-off (10 V to 9.1 V = 100%, 1.5 V to 0.6 V = 1%, <0.6 V = dim-to-off)
- Auxiliary output 12 V/100 mA
- Dual output voltage range
- IP66-rated case with silicone-based potting
|
|
- Surge protection:
- Combination wave IEC61000-4-5: 4 kV line-to-line/4 kV line-to-earth (higher surge is available upon request)
- 2.5 kV ring wave: ANSI/IEEE c62.41.1-2002 and c62.41.2-2002 category A
- 90°C maximum case hot spot temperature
- Complies with ENERGY STAR® luminaire specification and Design Light Consortium® (DLC) technical requirements
- UL Class P
- Worldwide safety approvals
|
Applications
|
|
|
- Area lighting
- Commercial lighting
- High bay applications
|
|
- Horticulture applications
- Outdoor LED lights
- Street lights
|